Allied Telesis AT-S97 - Manual (Page 93)

AT-S85 and AT-S97 Management Software User’s Guide
93
port Specifies a port. You can specify only one port.
The possible values are:
a Specifies the twisted pair port of a
channel.
b Specifies the fiber optic port of a
channel.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 101 or “SYSTEM
SHOW CHASSIS” on page 99. To view the ports of a
channel, refer to “SYSTEM SHOW INTERFACE” on
page 103.
port-state Enables or disables a port. The available settings are:
enable Activates the transmitter and receiver on a port.
This is the default setting.
disable Deactivates the transmitter and receiver on a
port.
auto-neg Activates and deactivates IEEE 802.3u Auto-Negotiation
and auto-MDI/MDIX on a port. When Auto-Negotiation is
activated, a port’s speed, duplex mode, and wiring
configuration are set automatically. The settings are:
enable Activates IEEE 802.3u Auto-Negotiation and
auto-MDI/MDIX on the port. This is the default
setting for twisted pair ports. It is also the default
setting for fiber optic ports that support Auto-
Negotiation, such as 100Base-SX ports. This
setting is not appropriate for fiber optic ports that
do not support Auto-Negotiation, such as
100Base-FX and 1000Base-F ports.
disable Deactivates IEEE 802.3u Auto-Negotiation and
auto-MDI/MDIX on a port.
speed Sets the speed of a twisted pair port. The available settings
are:
10 Sets the speed of a port to 10 Mbps.
100 Sets the speed of a port to 100 Mbps.
1000 Sets the speed of a port to 1000 Mbps. This
setting is applicable to the 10/100/1000Base-T
ports on the AT-MCF2032SP Module and on the
10/100/1000Base-T port on the management