Allied Telesis AT-S97 - Manual (Page 17)

AT-S85 and AT-S97 Management Software User’s Guide
17
ˆ Monitor the operations of the modules from an event log.
ˆ Send the event messages to a Syslog server on your network.
AT-S97
Command Line
Interface
The AT-S97 Management Software has a command line interface which
can be accessed either locally through the RS-232 Terminal Port on the
management module or remotely from your network using the Telnet or
Secure Shell application protocol. To access the interface, you must log on
to the management module with a valid manager name and password.
Note
The first management session of the chassis must be from a local
management session. For instructions, refer to “Starting a Local
Management Session” on page 18.
Manager
Privilege Levels
The management software has three manager privilege levels:
ˆ administrator
ˆ read-write
ˆ read-only
The privilege level of administrator is restricted to the management
module’s predefined manager account, which has the user name of
“manager” and the default password “friend.”
The management module can support ten additional manager accounts
with the privilege level of read-write and another ten accounts of read-only.
The read-write level is nearly identical to the administrator level of the
predefined manager account. It provides access to almost all of the same
parameters settings, with a few exceptions, detailed in Chapter 13,
“Manager Account Commands” on page 215. In contrast, the read-only
privilege level restricts a network administrator to just viewing the
parameter settings.
The privilege level required to perform a command is included in the
descriptions of the commands in this manual.
Note
Only the predefined manager account can have the privilege level of
administrator.