Allied Telesis AT-S97 - Manual (Page 165)

AT-S85 and AT-S97 Management Software User’s Guide
165
After designating an active master configuration file, do one of the
following:
ˆ To configure the modules in the chassis or stack according to the
settings in the newly designated active master configuration file, issue
the CONFIG RUN command. For instructions, refer to “CONFIG RUN”
on page 160. Do not issue the CONFIG SAVE command.
ˆ To overwrite the settings in the active master configuration file with the
current settings of the modules, issue the CONFIG SAVE command.
For instructions, refer to “CONFIG SAVE” on page 161.
Note the following before using this command:
ˆ To view the name of an active master configuration file, see “CONFIG
SHOW” on page 166.
ˆ The designated file must already exist. To view the configuration files
in the management module’s file system, see “FILE SHOW” on
page 191. Configuration files have a “.cfg” extension. To create a new
configuration file, refer to “CONFIG SAVE” on page 161.
For further information, refer to “Specifying the Active Master
Configuration File” on page 149.
Examples
This command designates the file “mc22.cfg” in the file system on the
management module as the active master configuration file. The chassis
has the ID number 0:
config set filesystem=system://0/m/mc22.cfg
This command designates the file “mcf2000 b12.cfg” as the active master
configuration file for the chassis with the ID number 0:
config set filesystem=system://0/m/"mcf2000 b12.cfg"