Allied Telesis AT-S97 - Manual (Page 136)

Chapter 7: Event Log and Syslog Client Commands
136
LOGGING SHOW
Syntax
logging show
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command is used to display the status of the event log and the syslog
client. An example of the information is shown in Figure 21.
Figure 21. LOGGING SHOW Command
The fields in the EventLog Information section are:
ˆ Status - The status of the event log. A status of Enable signifies that
the event log is storing event messages while a status of Disable
indicates that it is not storing messages. To set this value, refer to
“LOGGING ENABLE EVENTLOG” on page 131 and “LOGGING
DISABLE EVENTLOG” on page 129.
ˆ Severity Level - The severity level of the messages displayed by the
event log and sent to a syslog server. The severity levels from highest
to lowest are Critical, Major, Minor, and Event. The affected messages
are inclusive of the selected severity level and all levels above it. For
example, the Event severity level, the default setting, encompasses all
of the levels and so all of the event messages, while a setting of Major
selects just the Critical and Major messages. To set this value, refer to
“LOGGING SET EVENTLOG” on page 133.
The fields in the Syslog Information section are:
ˆ Status - The status of the syslog client. When the status of the client is
Enable, the management module can send events to a syslog server.
EventLog Information
Status .................. Enable
Severity Level .......... Event
Syslog Information
Status .................. Enable
Server .................. 149.22.122.8
Facility Code ........... 1