Allied Telesis AT-S97 - Manual (Page 79)

AT-S85 and AT-S97 Management Software User’s Guide
79
Note
Resetting a media converter module may result in the loss of some
network traffic.
Note
When a management module is reset, it will be unresponsive to
commands for approximately one minute as it initializes the AT-S97
Management Software.
Note
A media converter module will immediately resume forwarding
network traffic through its ports and channels when it is reset. It uses
the default settings for its parameter settings as it initializes its
management software, which takes approximately one minute.
During the initialization process, it will be unresponsive to
management commands. Afterwards, the module will configure its
ports and channels according to the settings in either its own
configuration file or the active master configuration file on the
management module, depending on the configuration overwrite
setting for the slot.
Here are the guidelines to using this command:
ˆ You can reset only one module at a time.
ˆ You can use this command to reset a management module or a media
converter module. However, you cannot use this command to reset a
power supply module, a fan module, or the AT-MCF2000S Stacking
Module.
ˆ If you reset the AT-MCF2000M Management Module, your
management session ends. To continue managing the chassis, start a
new session after the module has initialized its software, which takes
about one minute.
ˆ Resetting the AT-MCF2000M Management Module does not affect the
network operations of the media converter modules in the chassis.
ˆ If you reset a media converter module, you can use the SYSTEM
SHOW CLUSTER command or the SYSTEM SHOW CHASSIS
command to determine when a module has finished initializing its
management software.
ˆ To reset all of the media converter modules in a chassis with just one
command, refer to “SYSTEM RESET CHASSIS” on page 74.