Allied Telesis AT-S97 - Manual (Page 127)

AT-S85 and AT-S97 Management Software User’s Guide
127
ˆ If the management module and syslog server are on different
networks, the IP configuration on the management module must
include a default gateway specifying the IP address of the first hop to
reaching the server. For instructions, refer to Chapter 3, “IP
Configuration Commands” on page 47.
Command
Summary
Table 15 summarizes the event log and syslog client commands.
Table 15. Event Log and Syslog Client Commands
Command Description
LOGGING CLEAR
EVENTLOG on page 128 Clears all the events from the log.
LOGGING DISABLE
EVENTLOG on page 129 Disables the event log. No further
events are stored in the log.
LOGGING DISABLE SYSLOG
on page 130 Disables the syslog client. No
further events are sent to a syslog
server.
LOGGING ENABLE
EVENTLOG on page 131 Activates the event log which
begins to store event messages.
LOGGING ENABLE SYSLOG
on page 132 Activates the syslog client.
LOGGING SET EVENTLOG
on page 133 Specifies the severity level of the
event messages viewed in the log
and sent to a syslog server.
LOGGING SET SYSLOG on
page 135 Specifies the IP address of a
syslog server and a facility code
for the messages.
LOGGING SHOW on
page 136 Displays the status of the event
log and syslog client.
“LOGGING SHOW
EVENTLOG” on page 138 Displays the event messages in
the event log.