Allied Telesis AT-S97 - Manual (Page 160)

Chapter 8: Configuration File Commands
160
CONFIG RUN
Syntax
config run
Parameters
None.
Privilege Levels
Administrator and read-write.
Description
This command is used to configure the parameters settings of the
modules in the chassis or stack from the active master configuration file on
the management module. In some ways, this command is analogous to
resetting the chassis or stack, but with two important differences. The first
is that with this command the modules return to their normal network
operations quicker because they do not have to initialize their
management software. The second is that this command ignores the
configuration overwrite settings on the media converter modules, so that
modules with an overwrite setting of disabled still receive their settings
from the master configuration file.
There are two situations where you might use this command. The first is
after designating a new active master configuration file. To configure the
modules according to the settings in the new file, you could either reset
the chassis or stack, or you could issue this command.
The other situation where you might use this command is if you want to
return the modules to their previous configurations after making changes
that you did not save. For example, you might modify but not save the
settings of the ports on a media converter module, and later decide to
discard your changes.
Example
config run