Allied Telesis AT-S97 - Manual (Page 163)

AT-S85 and AT-S97 Management Software User’s Guide
163
If, after creating a new master configuration file, you want to designate it
as the active file on the management module, perform the CONFIG SET
command. For instructions, refer to “CONFIG SET” on page 164.
Example
This command creates the new master configuration file “mcf pat
traffic.cfg” with the current settings of all the modules in the chassis or
stack. The chassis with the management module has the ID number 0:
config save filesystem=system://0/m/"mcf pat traffic.cfg"