Allied Telesis AT-S97 - Manual (Page 202)

Chapter 10: Telnet Server Commands
202
TELNET SHOW
Syntax
telnet show
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command is used to display the status of the Telnet server on the
management module. The status of the server can be either Enable or
Disable. If the status is Enable, the management module can be managed
remotely with a Telnet client on your network. If the status is Disable, the
management module cannot be remotely managed. An example is shown
in Figure 40.
Figure 40. TELNET SHOW Command
Example
telnet show
Telnet Status ........ Enable