Allied Telesis AT-S97 - Manual (Page 81)

AT-S85 and AT-S97 Management Software User’s Guide
81
SYSTEM SET INTERFACE
Syntax
system set interface id= chassis / slot [/ channel ]
opmode=link-test|ml|sml
Parameters
id Specifies a media converter module or a channel. An ID
consists of the following parts:
chassis Identifies an ID number of a chassis. The range
is 0 to 31. For background information, refer to
“Chassis ID Numbers” on page 25.
slot Specifies the module you want to configure by
its slot number. Slot numbers are explained in
“Slot Numbers and Letters” on page 26. The
possible values are:
1 or 2 Specifies a slot number of a media
converter module in the
AT-MCF2000 Chassis. The left slot is
1 and the right slot is 2.
1 to 4 Specifies a slot number of a media
converter module in the
AT-MCF2300 Chassis. The slots are
number 1 (left) and 2 (right) in the top
row, and 3 (left) and 4 (right) in the
bottom row.
channel Specifies the channel you want to configure by
its channel number. You can specify only one
channel. The range is 1 to 12. Channel 1
consists of twisted pair port 1 and fiber topic port
1, channel 2 of twisted pair port 2 and fiber topic
port 2, and so on. You can specify only one
channel at a time. Or, omit this parameter to set
all of the channels on a media converter module
to the same operating mode.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 99 or “SYSTEM
SHOW CLUSTER” on page 101. To view the channels,
refer to “SYSTEM SHOW INTERFACE” on page 103.