Allied Telesis AT-S97 - Manual (Page 94)

Chapter 5: Port and Module Commands
94
module. This setting is not supported on the
twisted pair ports on the AT-MCF2012LC and
AT-MCF2012LC/1 Media Converter Modules.
duplex Sets the duplex mode of a port. The available settings are:
full Sets the duplex mode of the port to full-duplex.
This is the default setting for a fiber optic port
that does not support Auto-Negotiation.
half Sets the duplex mode of the port to half-duplex.
crossover Sets the wiring configuration of a twisted pair port. Auto-
Negotiation must be disabled on the port to set this
parameter. The available settings are:
mdi Sets the wiring configuration to MDI.
mdix Sets the wiring configuration to MDI-X.
ingress-rate-limit
Defines the maximum number of bits per second a port will
accept from the network device connected to it. The ranges
are 62 to 256000 kbps for the AT-MCF2012LC and
AT-MCF2012LC/1 Media Converter Modules, and 59 to
1000000 kbps for the AT-MCF2032SP Media Converter
Module.
egress-rate-limit
Defines the maximum number of bits per second a port will
transmit to the network device connected to it. The ranges
are 62 to 256000 kbps for the AT-MCF2012LC and
AT-MCF2012LC/1 Media Converter Modules, and 59 to
1000000 kbps for the AT-MCF2032SP Media Converter
Module.
Privilege Levels
Administrator and read-write.
Description
This command is used to configure the following parameter settings on a
twisted pair port or a fiber optic port in a channel on a media converter
module:
ˆ Port status
ˆ Auto-Negotiation
ˆ Speed and duplex mode
ˆ MDI/MDI-X wiring configuration
ˆ Ingress and egress filtering