Allied Telesis AT-S97 - Manual (Page 132)

Chapter 7: Event Log and Syslog Client Commands
132
LOGGING ENABLE SYSLOG
Syntax
logging enable syslog
Parameters
None.
Privilege Levels
Administrator and read-write
Description
This command is used to activate the syslog client on the management
module. After you enter this command, the module immediately begins to
send the event messages as they occur to the syslog server. The default
setting for the syslog client is disabled.
The IP address of the syslog server is specified with “LOGGING SET
EVENTLOG” on page 133. To display the current status of the syslog
client, refer to “LOGGING SHOW” on page 136.
Note
For the requirements of the syslog client, refer to “Syslog Client
Guidelines” on page 126,
Example
logging enable syslog