Allied Telesis AT-S97 - Manual (Page 88)

Chapter 5: Port and Module Commands
88
Description
This command is used to assign names to the channels on a media
converter module. Naming the channels makes them easier to identify.
Channel names can be viewed with “SYSTEM SHOW INTERFACE” on
page 103.
Examples
This command assigns the name “Region2” to channel 7 (twisted pair port
7 and fiber optic port 7) on a module in slot 2 in a chassis with the ID 0:
system set interface id=0/2/7 portname=Region2
This command assigns the name “NW_traffic” to channel 2 (twisted pair
port 2 and fiber optic port 2) on a module in slot 4 in a chassis with the ID
1:
system set interface id=1/4/2 portname=NW_traffic