Allied Telesis AT-S97 - Manual (Page 87)

AT-S85 and AT-S97 Management Software User’s Guide
87
SYSTEM SET INTERFACE PORTNAME
Syntax
system set interface id= chassis / slot / channel portname= name
Parameters
id Specifies the ID of the channel you want to assign a name.
The ID consists of the following parts:
chassis Identifies a chassis ID number. The range is 0 to
31. For background information, refer to
“Chassis ID Numbers” on page 25.
slot Specifies a slot number of a media converter
module. Slot numbers are explained in “Slot
Numbers and Letters” on page 26. The ranges
are:
1 or 2 Specifies a slot number of a media
converter module in the
AT-MCF2000 Chassis. The left slot is
1 and the right slot is 2.
1 to 4 Specifies a slot number of a media
converter module in the
AT-MCF2300 Chassis. The slots are
number 1 (left) and 2 (right) in the top
row, and 3 (left) and 4 (right) in the
bottom row.
channel Specifies a channel number on a media
converter module. You can specify only one
channel. The range is 1 to 12. Channel 1
consists of twisted pair port 1 and fiber topic port
1, channel 2 of twisted pair port 2 and fiber topic
port 2, and so on. You can specify only one
channel at a time. Or, omit this parameter to set
all of the channels on a media converter module
to the same operating mode.
portname Specifies a name of up to 20 alphanumeric characters for a
channel.
Privilege Levels
Administrator and read-write.