Allied Telesis AT-S97 - Manual (Page 30)

Chapter 1: Starting a Management Session
30
What to Configure First
This section has a few suggestions on what to configure during your first
management session. The initial management session must be a local
session. For instructions on how to start a local management session,
refer to “Starting a Local Management Session” on page 18.
Note
Although the management module comes with the default IP
address of 10.0.0.1 and subnet mask of 255.255.252.0, the initial
configuration must be a local session because the module’s Telnet
and SSH servers are initially disabled.
Displaying the
Chassis Modules
After logging on, enter this command:
system show cluster
The command is used to display and verify the management module and
the media converter modules in a chassis. An example is shown in Figure
5.
Figure 5. Displaying the Chassis Modules
Chassis Chassis Chassis MAC Master
ID Name Type Address Chassis
--------------------------------------------------------------------------------------
0 AT-MCF2000 11:22:33:44:55:55 Yes
AT-MCF2000
Slot ID Module Name Module Type Cfg Overwrite Software Version
------------------------------------------------------------------------------
M
AT-MCF2000M v3.0.0
1 AT-MCF2012LC Disable v3.0.0
2 AT-MCF2012LC/1 Disable v3.0.0
Chassis information
Management and media converter module information