Allied Telesis AT-S97 - Manual (Page 158)

Chapter 8: Configuration File Commands
158
CONFIG OVERWRITE
Syntax
config overwrite enable|disable id= chassis / slot
Parameters
enable Activates configuration overwrite on a media converter
module. At this setting, a module, when it is powered on or
reset, seeks its configuration settings from a management
card and a master configuration file. This is the default
value.
disable Deactivates configuration overwrite on a media converter
module. At this setting, a module uses the configuration
settings in its auxiliary configuration file in flash memory to
set its parameter settings whenever it is powered on or
reset.
id Identifies a media converter module. You can configure
only one module at a time. An ID number has the following
parts:
chassis Identifies an ID number of a chassis. The range
is 0 to 31. For background information, refer to
“Chassis ID Numbers” on page 25.
slot Identifies a slot number of a module to be
configured. For background information, refer to
“Slot Numbers and Letters” on page 26. The
possible values are:
1 or 2 Specifies a media converter slot in
the AT-MCF2000 Chassis. The left
slot is 1 and the right slot is 2.
1 to 4 Specifies a media converter slot in
the AT-MCF2300 Chassis. The slots
are number 1 (left) and 2 (right) in
the top row, and 3 (left) and 4 (right)
in the bottom row.
Privilege Levels
Administrator and read-write.