Allied Telesis AT-S97 - Manual (Page 208)

Chapter 11: Simple Network Management Protocol (SNMP) Commands
208
SNMP SHOW
Syntax
snmp show
Parameters
None.
Privilege Levels
Administrator, read-write and read-only
Description
This command is used to display the SNMPv1 and v2c community strings
and the IP addresses of the trap receivers. An example is shown in
Figure 41.
Figure 41. SNMP SHOW Command
Example
snmp show
SNMP Information:
Get Community...............public
Set Community...............private
TrapCommunity...............public
Manager 1 IP address........0.0.0.0
Manager 2 IP address........0.0.0.0
Manager 3 IP address........0.0.0.0
Manager 4 IP address........0.0.0.0