Allied Telesis AT-S97 - Manual (Page 92)

Chapter 5: Port and Module Commands
92
SYSTEM SET PORT
Syntax
system set port id= chassis / slot [/ channel ][/ port ]
port-state=disable|enable auto-neg=disable|enable
speed=10|100|1000 duplex=half|full
crossover=mdi|mdix
ingress-rate-limit=none|
value
egress-rate-limit=none| value
Parameters
id Specifies a port in a channel on a media converter module.
You can configure one port, both ports of a channel, all of
the twisted pair ports on a module, all of the fiber optic
ports, or all of the twisted pair and fiber optic ports. The ID
consists of the following parts:
chassis Identifies a chassis ID number. The range is 0 to
31. For background information, refer to
“Chassis ID Numbers” on page 25.
slot Specifies a slot number. For background
information, refer to “Slot Numbers and Letters”
on page 26. The values and ranges are:
1 or 2 Specifies a slot number of a media
converter module in the
AT-MCF2000 Chassis. The left slot
is 1 and the right slot is 2.
1 to 4 Specifies a slot number of a media
converter module in the
AT-MCF2300 Chassis. The slots are
number 1 (left) and 2 (right) in the top
row, and 3 (left) and 4 (right) in the
bottom row.
m Specifies the 10/100/1000Base-T
port on the management module.
channel Specifies a number of a channel with a port you
want to configure. The range is 1 to 12. Channel
1 consists of twisted pair port 1 and fiber topic
port 1, channel 2 of twisted pair port 2 and fiber
topic port 2, and so on. You can specify only
one channel. To configure all the twisted pair
ports or the fiber optic ports on a module, omit
this parameter.