Allied Telesis AT-S97 - Manual (Page 26)

Chapter 1: Starting a Management Session
26
Slot Numbers and Letters
Some of the commands in the management software programs have a
slot parameter for specifying a slot in an enclosure. You use this
parameter to specify the slot that contains the module you want to
configure with a command. The slots for the media converter modules are
identified by numbers and the slots for the power supply modules and the
management module are identified by letters.
Figure 3 shows the numbers and letters for the slots in the AT-MCF2000
Chassis.
Figure 3. Slot Numbers and Letters for the AT-MCF2000 Chassis
Table 1 lists the purposes of the slots in the unit.
AT-MCF2KPNL1 AT-MCF2KPNL1
1 2
A T -MCF2000
AT-MCF2KPNL2 AT-MCF2KPNL2
AT-MCF2KPNL3
MANAGEMENT A B
Slot 1 Slot 2
Slot A Slot M Slot B
Table 1. AT-MCF2000 Chassis Slots
Slot Module
1 and 2 These slots are for the multi-channel
AT-MCF2012LC, AT-MCF2012LC/1, and
AT-MCF2032SP Media Converter Modules.
A and B These slots are for the AT-MCF2000AC Power
Supply Module and the AT-MCF2KFAN Module.
M This slot is for the AT-MCF2000M Management
Module or the AT-MCF2000S Stacking Card.