Allied Telesis AT-S97 - Manual (Page 121)

AT-S85 and AT-S97 Management Software User’s Guide
121
NTP ENABLE
Syntax
ntp enable
Parameters
None.
Privilege Levels
Administrator and read-write.
Description
This command is used to activate the NTP client on the management
module. When the client is activated, it immediately begins polling for the
NTP server, up to fifteen times over twenty seconds. The default setting
for the client is disabled.
To set the IP address of the NTP server, use “NTP SET” on page 122.
Note
Review “NTP Client Guidelines” on page 118 before activating the
client.
Note
Your management session is suspended while the NTP client polls
for the server.
Example
ntp enable