Allied Telesis AT-S97 User Manual
Page 156
Chapter 8: Configuration File Commands
156
Figure 34. Blade Configuration - Port Operating Parameters
Here are the guidelines for modifying the commands in this section:
Each port must have its own command line.
A port can have more than one command line.
A command line cannot exceed eighty characters.
If you delete a port’s configuration command from the file, the port
operates with the default settings.
The ID parameter specifies just the channel number and the port letter.
The name of a media converter module and the temperature threshold are
controlled with the commands in the final part of a Blade Configuration
section, shown in Figure 35.
Figure 35. Blade Configuration - Module Name and Temperature
Threshold Section
The first two lines control the module’s name and temperature threshold.
The commands are a modified version of the SYSTEM SET MODULE
command, with the MYMODULE keyword substituting for the MODULE
keyword, as explained earlier in the System Configuration section. Do not
change the ID values. Though in all other cases a slot “0” designation
indicates the management module, this is not true for these lines in the
system set port id=1/a ingress-rate-limit=none egress-rate-limit=none
system set port id=1/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set port id=2/a speed=100 duplex=full crossover=mdi
system set port id=2/a ingress-rate-limit=128k egress-rate-limit=none
system set port id=2/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set port id=3/a ingress-rate-limit=none egress-rate-limit=none
system set port id=3/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set port id=4/a speed=10 duplex=full crossover=mdi
system set port id=4/a ingress-rate-limit=none egress-rate-limit=none
system set port id=4/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set mymodule id=1/0 name="none"
system set mymodule id=1/0 temperature-threshold=60
system set mymodule id=1/a temperature-threshold=60
system set mymodule id=1/b temperature-threshold=60
system set mymodule id=1/c temperature-threshold=60
configuration overwrite disable