Allied Telesis AT-S97 - Manual (Page 184)

Chapter 9: File System Commands
184
Since the slots are indicated with the wildcard “*”, all of the modules,
including the management module, receive the file. However, since the
AT-S85 boot loader is intended for the media converter modules, the
management module will discard the file and generate an error message,
which can be ignored.
This command downloads a new version of the AT-S97 boot loader onto a
management module. The IP address of the TFTP server is
162.101.11.12 and the name of the file is “ats97.bin”:
file download srcfile=tftp://162.101.1.12/ats97.bin
dstfile=system://*/m/bootblock
Note
The above example is the preferred command for upgrading the
boot loader on the management module.
This command downloads a new version of the AT-S85 boot loader onto
the media converter module in slot 1 in the chassis with an ID of 0. The IP
address of the TFTP server is 149.72.23.5 and the name of the file is
“ats85.bin”:
file download srcfile=tftp://149.72.23.5/ats85.bin
dstfile=system://0/1/bootblock
Examples of Downloading the AT-S85 and AT-S97 Management
Software
This command downloads a new version of the AT-S85 Management
Software onto all of the media converter modules in a chassis. The IP
address of the TFTP server is 150.24.44.65 and the name of the file is
“ats85.img”:
file download srcfile=tftp://150.24.44.65/ats85.img
dstfile=system://*/*/appblock
The asterisk is used to indicate all slots in the chassis which means the
management module receives the file as well. Since the AT-S85
Management Software is intended for media converter modules, it will
discard the file and generate an error message. You can ignore the
message.
Note
The above example is the preferred command for upgrading the
management software on the media converter modules in a chassis.
Downloading management software onto some but not all of the
modules of a chassis may cause compatibility problems.