Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 99)

Brocade Mobility 7131N-FGR Product Reference Guide 87
53-1001947-01
Configuring SNMP settings
4
2. Configure the RF Trap Thresholds field to define device threshold values for SNMP traps.
NOTE
Average Bit Speed,% of Non-Unicast, Average Signal, Average Retries,% Dropped and %
Undecryptable are not access point statistics.
3. Configure the Minimum Packets field to define a minimum packet throughput value for trap
generation.
Pkts/s Enter a maximum threshold for the total throughput in Pps
(Packets per second).
Throughput Set a maximum threshold for the total throughput in Mbps
(Megabits per second).
Average Bit Speed Enter a minimum threshold for the average bit speed in Mbps
(Megabits per second).
Average Signal Enter a minimum threshold for the average signal strength in dBm
for each device.
Average Retries Set a maximum threshold for the average number of retries for
each device.
% Dropped Enter a maximum threshold for the total percentage of packets
dropped for each device. Dropped packets can be caused by poor
RF signal or interference on the channel.
% Undecryptable Define a maximum threshold for the total percentage of packets
undecryptable for each device. Undecryptable packets can be the
result of corrupt packets, bad CRC checks or incomplete packets.
Associated MUs Set a maximum threshold for the total number of MUs associated
with each device.