Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 444)

432 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
System commands
8
BR7131N>admin(system.snmp.access)> add
Adds SNMP access entries for specific v1v2 and v3 user definitions.
Syntax
For information on configuring SNMP access settings using the applet (GUI), see “Configuring
SNMP access control” on page 80.
ad
d acl Adds an entry to the SNMP access control list with as the starting IP
address and and as the ending IP address.
v1v2c > >
: comm - community string 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
v3 >
: user - username 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
: sec - security - (none,auth,auth/priv)
: auth - algorithm - (md5,sha1)
: (required only if sec is - auth,auth/priv)
: pass1 - auth password - 8 to 31 chars
: (required only if sec is 'auth,auth/priv')
: priv - algorithm - (des, aes)
: (required only if sec is 'auth/priv')
: pass2 - privacy password - 8 to 31 chars
: (required only if sec is 'auth/priv')
The following parameters must be specified if is not none:
Authentication type set to md5 or sha1
Authentication password (8 to 31 chars)
The following parameters must be specified if is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password (8 to 31 chars)