Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 67)

Brocade Mobility 7131N-FGR Product Reference Guide 55
53-1001947-01
Chapter
4
System Configuration
In this chapter
• Configuring system settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56
• Configuring power settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
• Adaptive AP setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63
• Configuring data access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65
• Managing certificate authority (CA) certificates . . . . . . . . . . . . . . . . . . . . . . 69
• Configuring SNMP settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75
• Configuring Network Time Protocol (NTP) . . . . . . . . . . . . . . . . . . . . . . . . . . . 88
• Logging configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90
• Importing/exporting configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 92
• Updating device firmware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 94
The access point contains a built-in browser interface for system configuration and remote
management using a standard Web browser such as Microsoft Internet Explorer, Netscape
Navigator or Mozilla Firefox (version 0.8 or higher is recommended). The browser interface also
allows for system monitoring of the access point.
Web management of the Brocade Mobility 7131N-FGR Access Point requires either Microsoft
Internet Explorer 5.0 or later or Netscape Navigator 6.0 or later.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available from Sun’s Web site),
and be sure to disable Microsoft’s Java Virtual Machine if installed.
To connect to the access point, an IP address is required. If connected to the access point using the
WAN port, the default static IP address is 10.1.1.1. The default password is “admin123.” If
connected to the access point using the LAN port, the default setting is DHCP client. The user is
required to know the IP address to connect to the access point using a Web browser.
System configuration topics include:
• Configuring system settings
• Configuring power settings
• Adaptive AP setup
• Configuring data access
• Managing certificate authority (CA) certificates
• Configuring SNMP settings
• Configuring Network Time Protocol (NTP)
• Logging configuration
• Importing/exporting configurations