System commands, Br7131n>admin(system) – Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual
Page 412

400
Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
System commands
8
System commands
BR7131N>admin(system)>
Displays the System submenu. The items available under this command are shown below.
restart
Restarts the Brocade Mobility 7131N-FGR Access Point.
show
Shows Brocade Mobility 7131N-FGR Access Point system parameter settings.
set
Defines Brocade Mobility 7131N-FGR Access Point system parameter settings.
lastpw
Displays last debug password.
exec
Goes to a Linux command menu.
arp
Dispalys the access point’s arp table.
power-setup
Goes to the Power Settings submenu.
aap-setup
Goes to the Adaptive AP Settings submenu.
access
Goes to the Brocade Mobility 7131N-FGR Access Point access submenu where Brocade
Mobility 7131N-FGR Access Point access methods can be enabled.
cmgr
Goes the Certificate Manager submenu.
snmp
Goes to the SNMP submenu.
userdb
Goes to the user database submenu.
radius
Goes to the Radius submenu.
ntp
Goes to the Network Time Protocol submenu.
logs
Displays the log file submenu.
config
Goes to the configuration file update submenu.
fw-update
Goes to the firmware update submenu.
fips-test
Goes to the FIPS test submenu.
..
Goes to the parent menu.
/
Goes to the root menu.
save
Saves the configuration to system flash.
quit
Quits the CLI.