Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 450)

438 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
System commands
8
BR7131N>admin(system.snmp.traps)> add
Adds SNMP trap entries.
Syntax
Example
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index dest ip dest port community version
----------------------------------------------------------------------
1 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>add v3 201.232.24.33 555 BigBoss none md5
admin(system.snmp.traps)>list v3 all
index : 1
destination ip : 201.232.24.33
destination port : 555
username : BigBoss
security level : none
auth algorithm : md5
auth password : ********
privacy algorithm : des
privacy password : ********
For information on configuring SNMP traps using the applet (GUI), see “Configuring SNMP RF trap
thresholds” on page 86.
ad
d v1v
2
Adds an entry to the SNMP v1/v2 access list with the destination IP address set to , the
destination UDP port set to , the community string set to (1 to 31 characters), and the
SNMP version set to .
v3
Adds an entry to the SNMP v3 access list with the destination IP address set to , the destination
UDP port set to , the username set to (1 to 31 characters), and the authentication type
set to one of none, auth, or auth/priv.
The following parameters must be specified if is not none:
Authentication type set to md5 or sha1
Authentication password (8 to 31 chars)
The following parameters must be specified if is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password (8 to 31 chars)