Configuring port forwarding – Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual
Page 128
116
Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Configuring WAN settings
5
3. Click Apply to save any changes to the NAT screen. Navigating away from the screen without
clicking the Apply button results in all changes to the screens being lost.
4. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the NAT screen to the last saved configuration.
5. Click Logout to securely exit the Access Point applet. A prompt displays confirming the logout
before the applet is closed.
Configuring port forwarding
Use the Port Forwarding screen to configure port forwarding parameters for inbound traffic from
the associated WAN IP address.
To configure port forwarding for the Brocade Mobility 7131N-FGR Access Point:
1. Select Network Configuration -> WAN -> NAT from the Brocade Mobility 7131N-FGR Access
Point menu tree.
2. Select 1 to 1 or 1 to Many from the NAT Type drop-down menu.
3. Click on the Port Forwarding button within the Inbound Mappings area.
WAN IP Address
The WAN IP addresses on the NAT screen are dynamically
generated from address settings applied on the WAN screen.
NAT Type
Specify the NAT Type as 1 to 1 to map a WAN IP address to a single
host (local) IP address. 1 to 1 mapping is useful when users need
dedicated addresses, and for public-facing servers connected to
the Brocade Mobility 7131N-FGR Access Point.
Set the NAT Type as 1 to Many to map a WAN IP address to
multiple local IP addresses. This displays the mappings button in
the adjacent Outbound Mappings field. This button displays a
screen for mapping the LAN IP addresses that are associated with
each subnet.
Define the NAT Type as none when routable IP addresses are used
on the internal network.
Outbound Mappings
When 1 to 1 NAT is selected, a single IP address can be entered in
the Outbound Mappings area. This address provides a 1 to 1
mapping of the WAN IP address to the specified IP address.
When 1 to Many is selected as the NAT Type, the Outbound
Mappings area displays a 1 to Many Mappings button. Click the
button to select the LAN1 or LAN2 IP address used to set the
outbound IP address or select none to exclude the IP address.
If none is selected as the NAT Type, The Outbound Mappings area
is blank.
Inbound Mappings
When 1 to 1 or 1 to Many is selected, the Inbound Mappings
option displays a Port Forwarding button.
Port Forwarding
Click the Port Forwarding button to display a screen of port
forwarding parameters for inbound traffic from the associated
WAN IP address. for information on configuring port forwarding,
see