beautypg.com

Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual

Page 540

background image

528

Brocade Mobility 7131N-FGR Product Reference Guide

53-1001947-01

Configuring mesh networking support

9

1. Select Network Configuration -> Wireless -> Radio Configuration from the access point menu

tree.

2. Refer to the Radio Function parameter to ensure the radio has been designated for WLAN

Radio support.

NOTE

With this 4.0 release of the access point firmware, a new scheme for radio configuration and
WIPS server management has been implemented within the Quick Setup GUI applet. Up to
eight radio buttons are now available (depending on the number radios supported by the SKU).
These radio buttons define how WLAN and WIPS are supported amongst the radios available to
the access point. The options available depend strictly on the SKU supported. For information
on configuring a radio for WLAN and WIPS support see

“Basic configuration”

on page 41.

Refer to RF Band of Operation parameter to ensure you are enabling the correct
802.11a/n or 802.11b/g/n radio. After the settings are applied within this Radio Configuration
screen, the Radio Status and MUs connected values update. If this is an existing radio within a
mesh network, these values update in real-time.

3. Select the Base Bridge checkbox to allow the access point radio to accept client bridge

connections from other access points in client bridge mode. The base bridge is the acceptor of
mesh network data from those client bridges within the mesh network and never the initiator.

CAUTION
A problem could arise if a Base Bridge’s Indoor channel is not available on an Outdoor Client
Bridge's list of available channels. As long as an Outdoor Client Bridge has the Indoor Base
Bridge channel in its available list of channels, it can associate to the Base Bridge.