Multiple mounting options, Antenna support for 2.4 ghz and 5 ghz radios, Sixteen configurable wlans – Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual
Page 20: Support for 4 bssids per radio
8
Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Feature overview
1
For detailed information on locating the access point’s MAC addresses, see
on page 216 and
on page 218. For information on access point
Multiple mounting options
The access point attaches to a wall, mounts under a ceiling or above a ceiling (attic). Choose a
mounting option based on the physical environment of the coverage area. Do not mount the
access point in a location that has not been approved in a radio coverage site survey.
For detailed information on the mounting options available, see
Antenna support for 2.4 GHz and 5 GHz radios
The access point supports several 802.11a/n and 802.11b/g/n radio antennas. Select the
antenna best suited to the radio transmission requirements of your coverage area.
For an exhaustive overview of the antennas and associated components supported by the Brocade
access point family, refer to
Sixteen configurable WLANs
A Wireless Local Area Network (WLAN) is a data-communications system that flexibly extends the
functionalities of a wired LAN. A WLAN does not require lining up devices for line-of-sight
transmission, and are thus, desirable for wireless networking. Roaming users can be handed off
from one access point to another like a cellular phone system. WLANs can therefore be configured
around the needs of specific groups of users, even when they are not in physical proximity. Sixteen
WLANs are configurable on each access point.
To enable and configure WLANs on an access point radio, see
“Enabling Wireless LANs (WLANs)”
Support for 4 BSSIDs per radio
The access point supports four BSSIDs per radio. Each BSSID has a corresponding MAC address.
The first MAC address corresponds to BSSID #1. The MAC addresses for the other three BSSIDs
(BSSIDs #2, #3, #4) are derived by adding 1, 2, 3, respectively, to the radio MAC address.
If the radio MAC address displayed on the Radio Settings screen is 00:23:68:72:20:DC, then the
BSSIDs for that radio will have the following MAC addresses: