IAI America XSEL-S - Manual (Page 79)

4. RC Gateway Function setting
73
[Procedure 6] Parameter Writing
Write the edited operation mode setting parameters to MSEP. Click on the Write button
shown below and a confirmation window pops up. Click on the Yes button.
If the writing is finished in normal condition, writing complete window appears. Click OK.
[Procedure 7] MSEP Rebooting
A confirmation window for Gateway unit reboot opens. Click Yes to accept the reboot.
[Procedure 8] Parameter Writing Check
After rebooting, a confirmation window for parameter reading appears for confirmation of
the written contents. Click “Yes” to accept the reading.
Once the reading process is complete, confirm that the written contents are reflected.
If the writing process is not completed properly, have the setting complete again from
Procedure 1.
Establish the setting in ROBONET Gateway Parameter Setting Tool.
Write button