IAI America XSEL-S - Manual (Page 148)

6.
Appendix
142
*1 Disconnect the X-SEL communication cable from J3 (D-sub, 9-pin connector) on the SIO converter
and connect the RC PC software (RCM-101-MW: RS232C type or RCM-101-USB: USB type) to J1
(mini-DIN, 8-pin connector) on the SIO converter.
[1] Start the RC PC software.
[2] Click Setting, and then select Application.
Check the following items:
x Does the port shown on the communication setting screen correspond to the port number of the PC
port currently in use?
x Isn’t the last axis number set to a value greater than the number of connected axes?
(If any incorrect setting was found, set the item correctly and then restart the RC PC software.)
Click Setting, and then
select Application.
Check if this number is the
same as the port number of
the PC port currently in use.
Check if this value is
greater than the number
of connected axes.