2 x6004 access and login, X6004 access and login – ZyXEL Communications IP PBX X6004 User Manual
Page 512
Chapter 38 Troubleshooting
X6004 User’s Guide
512
The ALM LED is on.
1
Turn the X6004 off and on.
2
Disconnect and re-connect the power adaptor to the X6004.
3
If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1
Make sure you understand the normal behavior of the LED. See
2
Check the hardware connections. See the Quick Start Guide.
3
Inspect your cables for damage. Contact the vendor to replace any damaged
cables.
4
Disconnect and re-connect the power adaptor to the X6004.
5
Turn the X6004 off and on.
6
If the problem continues, contact the vendor.
38.2 X6004 Access and Login
I forgot the IP address for the X6004
1
The default LAN IP address is 192.168.1.12.
2
Use the console port to log into the X6004 (see
.
3
Use the command “network interface show ip all” to check the WAN and LAN
IP addresses of the X6004.
4
Enter the initrd screens and change the X6004’s IP address to the WAN/LAN
default (see