ZyXEL Communications IP PBX X6004 - Manual (Page 152)

Chapter 6 Server
X6004 User’s Guide
152
6.5 The BRI Screen
Use this screen to configure ISDN BRI interface settings on the X6004. Click
Configuration > PBX > Server Configuration > Server > BRI Configuration
to view the screen as shown next.
Note: You have to reboot the X6004 manually to apply changes in the Switch Type,
NT/TE mode, or TEI fields.
Figure 57 Server > BRI Configuration
Each field is described in the following table.
Rx Volume Select the volume level transmitted to the X6004. -6 is the quietest,
and 6 is the loudest.
Dial Interval Enter the number of seconds the X6004 should wait after you stop
dialing numbers (from FXS extensions) before it makes the phone call.
Country Code The signals used by telephone companies to indicate a busy line or an
available line differ by country. You must select the country code for the
location of the X6004. The X6004 can then detect whether the FXS line
is in use or available.
Apply Click this to save your changes.
Reset Click this to set every field in this screen to its last-saved value.
Table 24 Server > FXS (continued)
LABEL DESCRIPTION
Table 25 Server > BRI Configuration
LABEL DESCRIPTION
BRI
Configuration Use these fields to specify the ISDN BRI interface which you want to
configure.
Machine ID Specify the X6004 for which you want to configure ISDN BRI settings.
This field is only configurable if you have more than one X6004 working
in a ZyStack.