ZyXEL Communications IP PBX X6004 - Manual (Page 455)

Chapter 33 Remote Management
X6004 User’s Guide
455
The following table describes the labels in this screen.
33.4 The SSH Screen
You can use SSH to access the X6004’s command line interface. Specify which
interfaces allow SSH access and from which IP address the access can come. Click
Advanced > Remote Management > SSH tab to display the screen as shown.
Figure 261 Remote Management > SSH
The following table describes the labels in this screen.
Table 177 WWW > Add/Edit
LABEL DESCRIPTION
Access
Interface Select the interface(s) through which computer(s) may access the
X6004 using this service. Select ALL to allow the specified computer(s)
to access the X6004 through either LAN or WAN interface.
Address Type Select ALL to allow any computers to access the X6004 using this
service.
Select Host and specify the IP address of a trusted computer to allow
the computer to access the X6004 using this service.
Select Subnet and specify the IP addresses of a trusted subnet to allow
all computers from the subnet network to access the X6004 using this
service.
Apply Click this to save your changes and to apply them to the X6004.
Cancel Click this to begin configuring the fields again.
Table 178 Remote Management > SSH
LABEL DESCRIPTION
Activate SSH
Remote
Management
White List Select this to allow only computers which use IP addresses listed in this
screen to access your X6004 via an SSH connection.
# This field displays the index number of records in this table.
Access
Interface This field displays the interface(s) through which a computer may access
the X6004 using this service.