ZyXEL Communications IP PBX X6004 - Manual (Page 282)

Chapter 18 Outbound Line Group
X6004 User’s Guide
282
18.3 Add/Edit PRI Trunk
The screens for editing or adding a PRI trunk on the X6004 contain the same
fields. Only the screen used to add a PRI trunk is shown below. Click the Add (or
Edit) icon in the PRI Trunk section of the Outbound Line Group configuration
screen to view the screen as shown.
Figure 145 Add/Edit PRI Trunk
Each field is described in the following table.
Extension
Number This field is only available if you select Extension in the Apply AA
field. Type an extension or a hunting group number you want to
forward calls to.
Apply Click this to save your changes and to apply them to the X6004.
Cancel Click this to go to the Outbound Group screen without saving your
changes.
Table 89 AA for FXO Trunks (continued)
LABEL DESCRIPTION
Table 90 Add/Edit PRI Trunk
LABEL DESCRIPTION
Machine ID Select the ID of the X6004 on which you want to configure the PRI
interface. This is an internal name (not configurable) of the X6004. Only
one choice is shown if you have not configured ZyStack.
This field is not available when editing an PRI configuration.
Group Name Type the name of this PRI interface. This field can be 1-20
alphanumeric characters (A-Z, a-z, 0-9) and underscores (_).
Description Type the description for this PRI interface. This field can be 0-63
alphanumeric characters (A-Z, a-z, 0-9), underscores (_), hyphens (-)
and spaces. 0 means this field can be left blank.
Apply Click Apply to save your changes.
Back to
Outbound
Group/Cancel Click this to go to the Outbound Line Group screen without saving
your changes.