RISCO Group LightSYS 2 - Manual (Page 236)

Installer Event Log Messages
Page 236
Event Message Description
Overld rs ps=y Overload restore from 3A SMPS Y
Overload ps=y Overload from 3A SMPS Y
Panic Z=xx
Phone fail If the phone line is cut or the DC level is under 1V
Phone restore Phone line trouble restore
PIR rstr Z=xx
PIR trouble restore from Bus zone XX
PIR trbl Z=xx
PIR trouble from Bus zone XX
Police KF=yy Police (panic) alarm from remote control YY
Police KP=y Police (panic) alarm from keypad Y
POT.LD RS PS=y
Potential overload restore of 3A SMPS joined by 3A SMPS Y
POT.OVRLD PS=y
Potential overload of SMPS joined by 3A SMPS Y
PROX FAIL S=y
Fail in the proximity anti approach protection in siren Y
PROX OK SIREN=y
Proximity anti approach protection is restored in siren Y
PROX TMP RS S=y
Proximity tamper restore from siren ID =Y
PRX TMP SIREN=y
Proximity tamper from approaching siren ID=Y
PS=yOVER.R C=zz
Overload in 3A SMPS Y. Reset by user ZZ
Radio l.bat S=y Radio low battery trouble from siren Y
Radiol.bat rS=y Radio low battery restore from siren Y
Remote Prog The system has been programmed from the configuration
software
Reset: P=y C=zz Reset of partition ID=Y and user ID=ZZ
Restore Z=xx Alarm restore in zone no. XX
Rmt Arm:P=y Partition Y armed from the configuration software
Rmt Dis:P=y Partition Y disarmed from the configuration software
RMT Hom:P=y Partition Y armed in Stay mode from the CS software
SEISMIC OK Z=xx
Seismic Test in Bus zone XX has been restored
SEISMIC TR Z=xx
Seismic Test rouble in Bus zone XX
Self Fail Z=xx
Bus zone XX has failed the Self Test
Self OK Z=xx
Self Test in Bus zone XX has been restored
Siren=$ Lost Siren is regarded as lost following supervision test
Siren=$ Lost Rs The LightSYS2 received a signal from siren after it has been
regarded as lost