RISCO Group LightSYS 2 - Manual (Page 203)

Installer Programming
Page 203
2-Way WL Sounders
 
Label
As appropriate, rename the sounder’s label, as per the key definitions on
page 62.
 
Strobe
Use this menu to define parameters relating to the sounder
strobe


Control Follow Bell
Defines the strobe operation mode.

ALWAYS OFF ‐ The strobe is deactivated.

FOLLOW BELL — The strobe is activated when the siren bell
is triggered.
FOLLOW ALARM — The strobe is activated when an alarm
occurs in the selected siren’s partitions.


Blink 40
Defines the number of times that the strobe will blink in a minute.

20 [Times/Min]

30 [Times/Min]

40 [Times/Min]

50 [Times/Min]

60 [Times/Min]


Arm Squawk 01 01‐20 (seconds)
The time that the strobe will blink when the system is armed.
Note:
If the siren’s squawk strobe is defined as NO (Refer to the add/delete
module,

page 187) this parameter will be ignored.