RISCO Group LightSYS 2 - Manual (Page 211)

Using the Installer Non‐Programming Menus
Page 211
 MAC Address: View the MAC address of the IP card. This number is
used for identification of the LightSYS2 at the RISCO IP receiver when
using IP communication
Wireless: Displays the wireless module software version and enables to activate
the following tests for recognized wireless devices in the system
(keyfobs, wireless zones, wireless keypads).
 Communication Test— Displays the results of the last measurement
performed after the last transmission (last detection or last supervision
signal) of the selected device. To receive updated signal strength, activate
the detector prior to performing the communication test. For successful
communication, the strength of the signal should be higher than the noise
threshold level as measured during calibration of the main unit.
 Battery Test — Displays the results of the last battery test of the selected
device performed after the last transmission. OK message is displayed for
a successful test. For an updated value activate the device
Keypads: Displays the RP432 keypads software version number and momentarily
tests the keypad indicators.
Voice: Displays the voice module software version number and creation date.
LRT: Displays the Log Range Radio module software version and its active
protocol
Macro
Macro
LightSYS2 enables the installer or Grand Master record a series of commands and assign
them to a macro. For more information refer to LightSYS2 User Manual.
Stand Alone Keyfobs
Stand Alone Keyfob
LightSYS2 enables the installer or Grand Master to assign up to 200 keyfobs that can be
used for gate control. For addition information refer to LightSYS2 User Manual.