RISCO Group LightSYS 2 User Manual
Page 135

Installer Programming
Page 135
Follow Code
The code menu parameters enable you to program the activation of the selected
utility output when the user chooses the user functions menu (Selects
ACTIVITIES/UTIL OUTPUT, enters an authorized user code and presses
. The
installer designates the user code(s) for triggering the selected UO.
Refer to the LightSYS2 User’s Manual for additional details about triggering utility
output(s) via user codes.
Note:
The utility output is activated by entering a user code only if the Quick UO
parameter under System Control is defined as Disabled. When the Quick UO is
defined as Enabled, no user code is required.
To access the Code sub‐menus:
1. Access the outputs menu, as described on page 125.
2. From the Utility Output menu, press
. The following display appears:
UO=01 FOLLOWS:
4) CODE
3. Press
to display the following
:
CODES FOR UO=01:
00)GRAND N
4. Use the
and
keys to select from any of the 16 available users codes.
5. Use the
key to toggle between Y YES or N NO for each user chosen to trigger
the designated utility output.
6. Press
and proceed to Pattern of Operation, to set the pattern and duration of
operation