RISCO Group LightSYS 2 - Manual (Page 117)

Installer Programming
Page 117
  
Wireless Zones Configuration
The Wireless Zone Parameters menu contains parameters that enable
you to program the special parameters of a wireless zone. The options
are determined according to the wireless detector type:

1‐Way Non‐Restorable:

2‐Way WatchOUT: A dual technology outdoor detector with signal
processing based on two Passive Infrared (PIR) channels and two
Microwave (MW) channels.

2‐Way Magnet: (including shutter and universal)

2‐Way IR Beams

2‐Way Smoke

2‐Way PIR, Shock, Flood, Gas, Curtain, High Temperature, Zone
Button
Use the instructions below to set parameters for the relevant wireless
zone detector.
1-Way and 2-Way Smoke
Quick Keys Parameter Default Range
ZZ
Serial No.
The identifying 11‐digit number on the detector sticker
ZZ
Control
ZZ
Supervision No Yes/No
Determines if this zone will be supervised by the system expander
according to the time defined under the timer RX Supervision (see page
71)...
ZZ
LED Enable Yes Yes/No
Defines whether or not the LEDS operation mode is enabled
ZZ 
(2‐Way Smoke
Only)
Operation Mode Smoke & Heat S/H/S&H
Defines the detector operation mode.
SMOKE HEAT  SMOKE & HEAT