RISCO Group LightSYS 2 User Manual
Page 184
Installer Programming
Page 184
Quick Keys
Parameter
Default
Range
Power Supply
To choose/modify a power supply
1. Through the menu selection, the following display appears:
POWER SUPPLY:
ID=01 TYPE=
2. Use the
or
keys to position the cursor over the
power supply ID number for which you want to assign (or
delete) a power supply. The first PS must be assigned to the
first ID number, which is 01.
Note:
Make sure that the power supply’s physical ID number has
been ʺdip switchʺ programmed as described in in Setting Bus
Accessory ID Numbers, page 40.
3. Place the cursor on the TYPE field and use the
key to
toggle between the options provided to select the power
supply type, as follows:
NONE
PS02: 3A power supply
4. Press
. The following display appears:
P=1234 PS=1
YYYY
5. Use the
or
keys and the
key to assign the
partitions.
6. Press
The following display appears:
Controls: PS=1
1)BELL/L.SPEAKN
If a bell siren or loudspeaker is connected to the Power Supply
module, press
to select Y YES; otherwise, press
.
Note:
If YES is selected, the system will look for, detect, and sound
any problems in the sounder circuit.
7. Repeat the process for any other power supply modules in the
system, up to the systemʹs maximum of four, depending on
your installed model