RISCO Group LightSYS 2 - Manual (Page 195)

Installer Programming
Page 195
Quick Keys Parameter Default Range

Allocation
Note:
Allocation is step three of the three step Wireless Device Defining process.
See Step 1: Allocating a wireless expander  p. 185
Step 2: RX Calibration , above
Each wireless device must identify itself to the system receiver, in a
process termed “enrollment”.
Enrollment can be performed by sending an RF signal from each device,
or by typing the device’s unique serial code into the system. Enrollment
can be done locally using the keypad or remotely using the configuration
software.
LightSYS2 supports up to two wireless expanders. If two WL expanders
are allocated in the system, the first screen in the wireless devices
allocation menu series requires you to specify to which receiver the device
should be allocated:
Choose Receiver
1)ID1 TYP:WM
Note:
The number of wireless expanders present affects only the total possible
set of keypads: two keypads per each expander for a maximum of four.
The maximum 32 zones and 16 keyfobs are irrespective of the presence or
absence of a second expander.


By RF
 To allocate a wireless device:
1. Select 1) By RF and press .
2. Select the device to be used for the registration mode.
3. Select category ( 1)Zone, 2)Keyfob, 3)Keypad) and press .
4. Using the numeric keys, enter the desired device number and
press
5. The WL device is in learn mode. Send a write message from your
wireless device.
6. Continue entering the wireless zones attributes section.