RISCO Group LightSYS 2 - Manual (Page 149)

Installer Programming
Page 149
Quick Keys Parameter Default Range
 
SIM Number
The SIM phone number. The system uses this parameter to receive the
time from the GSM network in order to update the system time.
 
SMS Center Phone
A telephone number of the message delivery center. This number can be
obtained from the network operator.
 
GSM Network Sensitivity (RSSI) Disabled/Low/High
Set the minimum acceptable network signal level (RSSI level).
Options: Disabled (No troubles for low signal reception) / Low signal /
High signal

Prepay SIM
Allows programming parameters that will be used when a prepaid SIM
card is used in the system.
 
Get Credit by
Depending on the local network provider, the user can receive the credit
level of the prepaid SIM card by sending a predefined SMS command to
a defined number or by calling a predefined number through the voice
channel. The activation of the credit request can be done by the Grand
Master.

SMS Credit Message: Enter the message command as defined by
the provider and the provider’s phone number to which the credit
level SMS message request will be sent.

Voice Credit: Enter the provider’s phone number to which a call
will be established
 Service Command: Enter the service command message as defined
by the provider
 
Phone To Send
The provider’s phone number to which the credit level SMS message
request will be sent to or a call will be established, depending on the
selection in the Get Credit by parameter.
 
Phone To Receive
The provider’s telephone number from which an automatic SMS credit
status message will be sent from.