RISCO Group LightSYS 2 - Manual (Page 138)

Installer Programming
Page 138

Sub‐Installer Code: Used by a technician sent by the LightSYS2 installation company to
carry out restricted tasks defined at the time of system installation by the installation
technician. The Sub‐Installer can access with his code only those programming menus
predefined for his access.
This section describes how to perform the following:

Determine the authority level of each user code

Assign partition(s) to a specific code

Change the Grand Master, Installer, and Sub‐Installer codes

Upgrade the security level to a six‐digit code
After you access the Code Maintenance menu from the main Installer Programming menu, as
described in this section, you can access the following submenus:

User, page 137

Grand Master, page 140

Installer, page 141

Sub‐Installer, page 141

Code length, page 141

To access the Codes menu:
1. From the main Installer Programming menu, press [4], or press the /
keys until you find the number [4] Codes and then press . The first submenu 1)
User appears.
2. You are now in the Codes menu and can access the required submenus, as described
in the following sections

User
User rights can be defined by allocating each user a specific authority level and specific
partitions. Up to 16 users can be defined in the system
1. Access the 4) Codes menu
2. Press 1 to access the user menu
3. Select user and press
4. Set partition and authority level as follows