RISCO Group LightSYS 2 - Manual (Page 126)

Installer Programming
Page 126
 To access the Utility Output menu:
1. From the main Installer Programming menu, press

, or press the /
keys until you find the number 3)UTILITY OUTPUT option and then press .
2.
Enter a two‐digit number for the Utility Output that you want to program, using a
leading zero for numbers between 1 and 9 (for example, 01, 02, and so on) and then
press .
You can now program the selected Utility Output. Use the information shown
below.
Note
When selecting an output the display “(x:yy) represent the output location in the system. In
the 0:yy designation, the 0 represents denotes that the output is on the main unit and is not
assigned to an output expander. The yy represents the output ID number (up to 14).

Nothing
The Nothing option enables you to disable the selected Programmable Output.
1. Access the Utility Output menu and select an output.
2. Press to disable the selected utility output.

Follow System
The System menu contains Utility Output parameters that follow the System Event.
Utility Outputs: System
Quick Keys Parameter
 
Bell Follow
Activates when a bell is triggered. If a bell delay was defined, the utility
output will be activated after the delay period.
 
No Telephone Line
Activates when a telephone line fault is detected. If a PSTN Lost Delay
time period is defined, the utility output will be activated after the delay
time.
 
Communication Failure
Activates when communication with the MS cannot be established.
Deactivates after a successful call is established with the MS.