RISCO Group LightSYS 2 - Manual (Page 103)

Installer Programming
Page 103
Quick Keys Parameter Default Range

ZZ

Tamper
For tamper detection. This zone operates the same as 24 hours zone, but
it has a special reporting code.
Note:
For this zone type the zone sound is determined according to the
Tamper Sound defined under 1) System 4) Sound  1) Tamper

ZZ

Technical
This zone operates the same as 24 hours zone, its report code should be
manually set according to the relevant detector connected to the zone.

ZZ

Water
For flood or other types of water detectors. This zone operates the same
as 24 hours zone, but it has a special flood report code.

ZZ

Gas
For Gas (natural gas) leak detector. This zone operates the same as 24
hours zone, but it has a special gas report code.

ZZ

CO
For CO (Carbon Monoxide) gas detectors. This zone operates the same
as 24 hours zone, but it has a special CO report code.

ZZ

Exit Term
This type of zone is used to avoid a false alarm by acting like an Exit
(OP)/Entry zone.
When triggered (after arming the system and closing the door or
opening the door, arming the system, and closing the door), the systemʹs
Exit Delay time period will be shortened to 3 seconds.
When you re‐open the door, the entry time restarts.

ZZ

High Temperature
For detector temperature (hot or cold). This zone operates the same as 24
hours zone, but it has a special report code.

ZZ

Low Temperature
For detector temperature (hot or cold). This zone operates the same as 24
hours zone, but it has a special report code.