RISCO Group LightSYS 2 - Manual (Page 12)

Introduction
Page 12
LightSYS2 Features
Main Panel
The main panel is the foundation of the systemʹs operation and has the following features:
8 basic hardwired zones
4 Utility Outputs:
o 1 x relay (programmable output) (3 Amps)
o 3*100mA opto‐relays
Box tamper input (normally open)
Bell tamper input (using a 2.2KΩ end‐of‐line resistor)
4‐wire bus with ʺquick connectorʺ from the main panel.
Power for the operation of an external sounder
Offers the required type of voltage for one or more electronic sirens, bells, or
loudspeakers, respectively
Supports more than 25 zone types
4 zone terminations, including: closed‐circuit (NC), open‐circuit (NO), end‐of‐line
(EOL) resistors, and double end‐of‐line (DEOL) resistors
Configurable zone resistance
500 Event log on board
Polycarbonate plastic (1.5 A) or metal (1.5 or 4A)
Zone Expansion
Support for additional 24 wired / wireless zones
Zones expansion using 8‐Zone wired expander (Max 3 expanders) or Bus Zones
expander
Bus zones support (maximum 32)
Up to two wireless 868MHz or 433MHz expansion modules
4 zone terminations, including closed‐circuit (NC), open‐circuit (NO), end‐of‐line
(EOL) resistors, double end‐of‐line (DEOL) resistors
Configurable zone resistance
Supports more than 25 zone types
Forced setting zone capability
Wireless Capabilities
Up to two WL receivers per LightSYS2 system
The wireless expansion module includes the following features:
o
Up to 32 supervised wireless zones (bus mode)
o Up to 16 multi‐function keyfobs (bus mode)
o Up to 200 stand‐alone keyfobs (bus and stand‐alone modes)
o Two utility outputs (1A relays)
o Rolling code technology