Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 760)

760 K2 Storage System Instruction Manual September 7, 2007
Chapter 18 Administering and maintaining the K2 Storage System
FTP bandwidth into consideration:
NOTE: One Gig ISLs must be an odd number (3 or 5).
• Port count — The number of client connections, server connections, FTP/
streaming connections, and other connections determine how many ports are
required. As the port count increases, you must use switches with more ports and/
or multiple switches. When multiple switches are used, the port count assigned to
each VLAN and the ports used for ISLs must be considered.
Based on these factors, determine the number of switches, the number of ports on each
switch, and the ISLs required for your system needs. You can find procedures for
configuring the HP ProCurve switch in the chapters elsewhere in this manual for
installing each level. Adapt the procedures according to your switch design as you
configure your switches.
Configuring a switch through the K2 Configuration application
In the K2 Configuration Application, features for working on a Ethernet switch are as
follows:
From the K2 System Configuration application, you can click the Configure Switch
button to open the switch’s web configuration application. Refer to the installation
procedures elsewhere in this document for switch configuration information.
Maximum FTP bandwidth Trunk/ISLs required
Less than 100 MB/sec A trunk with three 1 Gb/s ISLs
100 - 300 MB/sec A trunk with five 1 Gb/s ISLs
More than 300 MB/sec A trunk with two 10 Gb/s ISLs
Select the
Ethernet switch... To make these
features available.