Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 692)

692 K2 Storage System Instruction Manual September 7, 2007
Chapter 18 Administering and maintaining the K2 Storage System
Adding devices to a K2 Storage System
Refer to the following topics to add devices to an existing K2 Storage System:
• “Adding an iSCSI client”
• “Adding an Ethernet switch”
• “Adding a K2 Media Server”
Also refer to “Adding a K2 Media client” on page 713 .
Adding an iSCSI client
Refer to the documentation for the type of iSCSI client you are adding. If you are
adding a Aurora Edit, refer to the Aurora Edit Installation and Configuration Guide.
The options and configurations for generic iSCSI clients are different than those
available for a K2 Media Client, so you should not attempt this procedure without
specific instructions for the type of iSCSI client you are adding.
The requirements for adding an iSCSI client to an existing K2 Storage System are as
follows:
• You must be logged in to the K2 System Configuration application with
permissions equivalent to K2 administrator or higher.
• The devices of the K2 Storage System do not need to be offline, and there is no
restart of devices required.
To add an iSCSI client to an existing K2 Storage System, do the following:
1. In the tree view, select the name of the K2 Storage System, which is the top node
of the storage system tree.
2. Click Add Device . The Add Device dialog box opens.
3. Select Generic Client .
4. Click OK . The new client appears in the tree view.